A Summary Of Tips Not To
Forget in Laying Tiles

Correct execution in laying tiles is essential to ensure a perfect final result from a technical and aesthetic point of view. Our advice, although deriving from years of experience, are to be considered purely indicative and are outside specific responsibilities, of competence of the professionals of the sector to whom you can rely for an optimal installation. To best enhance the characteristics of the material, it is recommended to follow the following suggestions when laying tiles on the floor.

Step 1


Make sure that the substrate is suitable for the intended use of the floor , especially when heavy loads are expected to pass. It is necessary to provide for the insertion of expansion joints, necessary in case of large surfaces, respecting the structural joints of the building.

Step 2


The tiles can be laid either with glue or with mortar, leaving minimum joints of 2-3 mm and using spacing crosses. If the glue laying system is used (suitable for areas subject to high foot traffic or the passage of heavy loads), the surface must be perfectly flat so that the tiles can be fixed securely to the base.

For the choice of the adhesive, and for applying the adhesive, follow the manufacturer’s instructions carefully.Take the tiles from different boxes in order to mix them.

Step 3


For particular types of workmanship, use suitable, professional tools, always checking their cutting capacity in advance and replacing worn parts when necessary. For precision cutting, use a traditional damp cutter or tile cutting tool. To make holes, use a water grinder for porcelain stoneware. To avoid exposing the tiler to potentially damaging dust, the ceramic material should not be cut dry.

Step 4


When laying tiles with traditional adhesives, grout the floor after 24/48 hours, or after 4 hours if rapid drying adhesives are used.

If coloured sealants are to be used, use only ready-prepared products, following the manufacturer’s instructions to the letter. Cement grouts in tone-on-tone shades are to be used, and it is advisable to avoid light-coloured grouts on dark materials and vice-versa: in such cases, a test should be carried out on a few tiles before laying.

Step 5


After the laying and grouting operations, the floor must be washed carefully to remove any residue. Clean a few square metres at a time, using any anti-scaling detergent, except for products containing hydrofluoric acid, as established by the EN 14411 standard, suitably diluted in water. Rinse several times with clean water, using a suction cleaner to remove excess water.

Once the floor is perfectly clean and dry, it should be protected with PVC and PLURIBALL sheets to avoid damage during the finishing works on the construction site. Wait at least 48-72 hours before walking on the floor as normal.

Step 6


Ceramic Floor Tiles is a low-maintenance material that does not require particular attention. How and how often it is cleaned will depend on the use and extension of the flooring.

For effective maintenance, it is advisable not to let dirt settle on the surface for too long, and to use detergents specifically for the use of the flooring and the main kind of dirt present.

CIn normal conditions, it is sufficient to use a neutral or alkaline detergent and rinse with clean water. Care must be taken if concentrated chemical products are to be used, and the manufacturer’s instructions must be followed carefully.orrec

For polished materials, especially with a light, even colour, if they are to be used in areas that get dirty easily, it is advisable to apply a protective treatment, to make simple maintenance even easier.

The treatment is easy to carry out, and must be applied to perfectly clean, dry flooring, using products specifically for ceramic floor following the manufacturer’s indications.